Dimension and Schematic:

Usage Instruction:

1. Connect the BNC connector to the device and tighten it

2. Press and push down the half clamp

3. Put the wire to be tested into the open the clothes-pin. 

4. Close the clothes-pin and lock it

Electrical Parameter:

Attention:

1. Please note that prolonged over current use may damage the product.

2. Do not store or use this product in the environment of directly exposed to sunlight, high temperature or high humidity or condensation. The product may be damaged, the insulation will be deteriorated in these condition.

3. Do not to drop the product or suffer from other mechanical shocks, which may damage the surface of the core and affect the measurement accuracy.

4. Keep the jaws & the core slit without foreign matter, which may affect the clamping action.

5. Holding Clamp Closed When storage, in order to avoid dust or dirt buildup on the core engagement surface, foreign maters may affect the measurement performance.

6. When disconnecting the BNC connector, be sure to rotate the lock before releasing the connector. Pulling the connector or pulling the cable (under lock unreleased) will damage the connector.

7. To prevent damage to the connected instrument, do not connect or disconnect the sensor in the event of charging (working statue) .

8. Note: Only one wire can be clamped in the center of the chuck. If you clamp the single-phase (2-wire) or three-phase (3-wire) cable at the same time, the device will not generate any readings.

9. The above parameters are only for reference as typical data, customer-made is subject to customer’s request.